Ambient Weather Support

Outdoor Temperature Sensor Does Not Communicate To The Display Console.

  1. The LED on the front of the sensor (see image below, #1) should flash when you put the batteries in and once per minute thereafter. If it is not flashing, it may need to be replaced.
  2. Make sure the sensor is transmitting on channel 1. Remove the battery compartment from the back of the sensor, and make sure the three position switch is in the far left hand position.  if it is not, set the switch to channel 1 and then power down and up the remote sensor by pressing the reset button.
  3. Make sure the console is displaying Channel 1. A common mistake is to switch the console to channel 2 or 3. To switch back to channel 1, press the UP button on the front of the console to switch to channel 1.
  4. If the sensor(s) have stopped communicating to your console,  it may be as simple as placing the remote(s) (powered up) about 10 feet away from the console, power down and up the console by removing one or more batteries, disconnecting from AC power, wait 30 seconds, and put the batteries back in, then wait several minutes to resync.DO NOT TOUCH ANY BUTTONS and look for the search icon. Wait until the search icon turns off before pressing any buttons.Again, make sure both the console and remote are on channel 1.
  5. If the problem persists, we have a one year warranty. To replace under warranty, please visit: www.AmbientWeather.com/rma.html