Ambient Weather Support

If a specific sensor or multiple sensors stop communicating to the display console, you can resynchronize the sensor(s) without resetting the console.

If a sensor loses communication, dashes (–.-) will be displayed.  If a specific channel is lost, press the CH/+ button to display that channel prior to entering the search mode.

To reacquire the lost signal, press and hold the CH/+ button for 3 seconds to enter the sensor search mode.

The icon REG will appear. You can synchronize one or all of individual sensors. Press the [+] or [-] key to toggle between the following sensors:

• CH. Synchronizes Channel 1-8 Sensors (dependent on which channel is displayed before entering the Sensor Search Mode*).
• WIND. Synchronizes Wind Sensor
• RAIN. Synchronizes Rain Sensor.
• ALL. Synchronizes All Sensors.
• NOT. Do nothing and exit the Sensor Search Mode.

After selecting one of the above options, press the SET key to resync, and the display will return to normal mode. Do not press any buttons until the synchronization is complete.  The remote search icon   will display constantly for 3 minutes until the signal is reacquired.

If the problem persists:

Power down the console by removing AC power and the batteries and wait 30 seconds.

Reinsert AC power and then the batteries.  Do not press any buttons until the synchronization is complete.  The remote search icon   will display constantly for 3 minutes until the signal is reacquired.

Product Manual
https://ambientweather.com/mwdownloads/download/link/id/537/

Product Page
https://www.ambientweather.com/amws12.html